Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuring IP Multicast

Hello Guys,

please help me . I am trying to configure IP Multicast on cat 6509 and 3548xl

the customer have Redundant cat6509 with HRSP configure , on the Etage two cat 3548 redundant connected to Cat 6509 with Gigabit uplink.

the custoer wannt to use ghost for software update

i enable multicast-routing on both cat6509 and ip pim spare-dense-mode on VLANs. I cannot set the command "set multicast router mod/port i don´t know why,

------------------------------------------------------------------

6509_unten> (enable) set multicast router 5/3

Failed to add port 5/3 to multicast router port list.

----------------------------------------------------------------

please could somone help me ? do you have any config Example ?

Thanks for any help

AF

2 REPLIES
Silver

Re: configuring IP Multicast

AF,

I would recommend enabling IGMP snooping (set igmp enable) and let the multicast router ports be dynamically learned. This is the preferred method. Here's a link that shows the multicast configuration guide for the 6500's.

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_configuration_guide_chapter09186a008007f319.html

Hope this helps,

Don

New Member

Re: configuring IP Multicast

Thanks Done,

the customer is using GhostCasting. I configure igmp and Pim like in the manuel but cannot have this working.

does some one have any experience with GhostCasting and Switch / Router Network?

Thanks for any help

AF

135
Views
0
Helpful
2
Replies