Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring IP on a 2500 series router

I am having trouble configuring the IP for a 2500 series router.

I am trying to connect the network 10.0.0.0 /24 with 10.0.2.0 /24 with a serial network of 10.0.3.0 /24 in between (We have a WAN simulator providing this)

My problem is that when I try to assign the IP address 10.0.0.3 /24 to interface E0, I get a

bad mask /24

error. I cannot configure the address. I can set the E0 ip address to most anything else, just not the 10.0.0.0 /24 network.

Any help would be appreciated.

Cheers,

Dave

2 REPLIES
New Member

Re: Configuring IP on a 2500 series router

try enabling subnet-zero under config. Believe this will allow 10.0.0.3 /24.

New Member

Re: Configuring IP on a 2500 series router

Worked like a charm. Thanks much.

Dave

219
Views
0
Helpful
2
Replies