Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuring line command on ISND PRI

Hi,

I have the following command configured on an Async line.

line 129

no motd-banner

no exec-banner

exec-timeout 0 0

flush-at-activation

modem InOut

autocommand telnet <ip address> <port>/noecho

transport preferred telnet

transport input all

stopbits 1

flowcontrol hardware

Which is used byan appplication to connect automatically.Now we have planned to used and ISDN PRI, please tell me how do i configure the same command on isdn PRI

1 REPLY
New Member

Re: configuring line command on ISND PRI

You can not use the same commands in PRI configuration.

Thease commands are only for line comands, used for configuring the physical parameters of async ports.

Where as if you have a digital modem card in this router and you are making anlog call to remote end you can configure the same parameters under line configuration and map the modems to PRI under PRI interface configuration using

suppose pri interface is serial1/0

interface serial 1/0:15

isdn incoming-voice modem

85
Views
0
Helpful
1
Replies