Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring Preferential Routes

Is there a way to configure a static routing table with preferred routes?

We just installed a wireless wan and are still using the T1 we had in place as a failover link. I want to set my routing table to use the Wireless first, and if necessary to use the T1 in case the wireless fails. We don't want the T1 to be used unless the wireless fails, regardless of whether it is the best route.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Configuring Preferential Routes

make the admin distance higher on the T1 routes i.e.

ip route x.x.x.x x.x.x.x. next hop ip Admin distance

1 REPLY
Silver

Re: Configuring Preferential Routes

make the admin distance higher on the T1 routes i.e.

ip route x.x.x.x x.x.x.x. next hop ip Admin distance

222
Views
0
Helpful
1
Replies