Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring R2 Signaling on Cisco 3640

Is it possible to configure R2 signalling for Cisco 3640 E1 Controller so what 24 timeslots are used for dial-up clients and other 6 timeslots arer used as uplinks to another 3640 router?

Thanks in advance.

1 REPLY

Re: Configuring R2 Signaling on Cisco 3640

Often times complex configuration issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

99
Views
0
Helpful
1
Replies
CreatePlease to create content