Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

configuring separpate Inbound and outbound traffic

Anyone out there has any good sample configuration of separating Inbound and outbound traffic on 3640 router using two diff. slot modules.

Trying to setup incoming and outgoing traffic separate.

Thanks.

2 REPLIES
New Member

Re: configuring separpate Inbound and outbound traffic

If I understand what you are trying to do, this is done with the "transmit-interface" INTERFACE command. Check the following link for some information.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/np1_c/1cprt2/1cip.htm#18783

New Member

Re: configuring separpate Inbound and outbound traffic

Yes

Thanks.

104
Views
0
Helpful
2
Replies
CreatePlease login to create content