configuring separpate Inbound and outbound traffic

[williamkim]

Anyone out there has any good sample configuration of separating Inbound and outbound traffic on 3640 router using two diff. slot modules.

Trying to setup incoming and outgoing traffic separate.

Thanks.

[godblesses]

If I understand what you are trying to do, this is done with the "transmit-interface" INTERFACE command. Check the following link for some information.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/np1_c/1cprt2/1cip.htm#18783

[williamkim]

Yes

Thanks.