Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuring SNMP variables on CatIOS

Anyone know what are the commands needed to configure the chassis ID on a CatIOS switch? That is I'm looking for something equivalent to the command "snmp chassis-id" on an IOS switch/router. Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Configuring SNMP variables on CatIOS

Hello,

AFAIK there is a SNMP engine ID used on CatOS but you are not able to change it.

I'm using set system location or set system contact to define my device inventory numbers.

Regards,

Milan

1 REPLY

Re: Configuring SNMP variables on CatIOS

Hello,

AFAIK there is a SNMP engine ID used on CatOS but you are not able to change it.

I'm using set system location or set system contact to define my device inventory numbers.

Regards,

Milan

86
Views
0
Helpful
1
Replies
CreatePlease to create content