Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
285
Views
0
Helpful
1
Replies

Configuring the Controller

e.frias
Level 1
Level 1

‎06-06-2003 07:47 AM - edited ‎03-02-2019 07:56 AM

Hi,

I have a WAN card (the VWIC-1MFT-E1=) for a 2611XM router, and I need this interface works at 75 ohms, can I change the impedance of the controller from command line or I need to change something physically to make this?

Thanks in advance!

E. Frias

Labels:
0 Helpful
1 Reply 1

deilert
Level 6
Level 6

‎06-06-2003 08:29 AM

If you do a sh controllers t1 or e1 it will show balanced or unbalanced , unbalanced is 75 ohm

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents