Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Configuring the Controller

Hi,

I have a WAN card (the VWIC-1MFT-E1=) for a 2611XM router, and I need this interface works at 75 ohms, can I change the impedance of the controller from command line or I need to change something physically to make this?

Thanks in advance!

E. Frias

1 REPLY
Silver

Re: Configuring the Controller

If you do a sh controllers t1 or e1 it will show balanced or unbalanced , unbalanced is 75 ohm

185
Views
0
Helpful
1
Replies