Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuring the pix

Has anyone configured a pix to be seen by RME. if so could you please point me in the direction of documention examples on how to do this. I can ping the pix 515 from the server dos prompt but CW2000 R5 will not add it to the inventory.

I need the pix commands

TY

Mike

3 REPLIES
Blue

Re: Configuring the pix

PIX requires 6.1(1) min for RME 3.4 support. Make sure that you're adding the PIX with correct device credentials for RME to add it in the inventory, including SNMP credentials.

Community Member

Re: Configuring the pix

TY

I know that, I need to know if the pix requires any special config to permit managment

Mike

Blue

Re: Configuring the pix

No. As long at the RME supports the device and the credentials are correct, it should work.

79
Views
0
Helpful
3
Replies
CreatePlease to create content