That's not really what I am looking for. I am looking to setup various 802.1Q VLANS on the router. I did some checking and it seems like the 851 only supports 1 VLAN. The 871 model seems to support 4 802.1Q VLANS with the Adv IP image. So now it seems like I have to get an 871 but I am still going to need some help when I get it. I would like to setup 4 802.1q VLANS on the 871. I need to assign specific IPs and VLAN IDs to this router and I need it to route between the VLANs' IP subnets. Is this possible?
Diego, your initial question was not that clear as your second post. I am quite sure Edison would have pointed you on the right direction, do not just low rate post at a first glance, but be more clear in your question specially when seeking assistance. The models that do support 802.1q vlan, and 802.1q trunking are 871,876,877,878. for future reference there is a link you can check for features you need by specific platforms, you can check software advisory tools for acurate features information .
Sorry about the rating. I thought that some rating is better than no rating. Besides my questions was clearly asking about an 850 and dot1.q trunking and I was referred to a config for an 870 with a VLAN setup that the 850 doesn't support.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...