I have to configure some 256 K and 384 K circuits.. nothing special simply HDLC.
I have purchased a WIC-1DSU-T1 which is supposed to a CSU integrated into the IOS. What specific commands do i use to configure this module and slice out the proportionate number of channels for my 256K and 384K circuits..
Yes you set the service-module t1 timeslots 1-4 for the 256k links. And 1-6 for 384. the other important info is the framing ( esf or sf ) and linecode ( b8zs and ami respectivly) other than encapsulation type and no shutdown will bring up your interface.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...