i have a 1720 series router i intent to connect it to another router but i only have a wic. is there any way to connect it to another router? if yes which series of router should i get? please advice. thanks a lot in advance.
I wanted to connnect two router. i look at the wic it is stated there serial 1 i remove the moduler and it is stated WIC T1. i also have a cable which which one end is connect to the WIC and the other end is V.35. is the information sufficent enough? or do you think it is possible for me to e mail you the pic of the WIC? please advice. thanks a lot in advice. i really appreciate you help.
It sounds like your WIC is a WIC-1T if it has a V.35 cable. The other end of the cable is a DB-60 male connector (4 rows of 15 pins each row). Is the V.35 end of the cable male or female? If it is male, it is probably a DTE cable.
If you have another Cisco router with a serial interface, you can put a cable on that serial port with DCE pinouts and female V.35 connector. Then, plug the two cables together, making a serial crossover cable connection.
On the serial interface with the DCE cable directly attached to it, run the "clockrate xxxxxxx" command, where xxxxxx is a number. Here's a configuration example:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...