Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CONNECTING 3550 WITH WIRELESS DEVICE

Hi,

I´m have a probelm when I Tried to connecting a Wireless Multipoint Device ROR 1100 form Orinoco to 3550.After few minutes of connection, the line protocol of this port goes down.The port is configured like a L2 with no other issue.Before this switch was arrive, there was installed a DLink switch and the connection works fine.Would you have and idea how can i fixed?

Javier

1 REPLY

Re: CONNECTING 3550 WITH WIRELESS DEVICE

Are you running software that is older than 12.1(14)?

In that case this could be due to sw-issues and I would recommend an upgrade first.

After that, you should check again.

Regards,

Leo

99
Views
0
Helpful
1
Replies