Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Connecting a 9216i toa 6509-E using Hybrid Mode OS.

I have connected a 9216i to the uplink port of the SUP 720 card in a 6509-E Cat Switch, and have configured that port for Vlan 2. But I cannot ping the 9216i. I have created a trunk port to a router for Vlan 1 and 2 using dot1q. Interface says connected.

Any help is appreciated.

2 REPLIES
VIP Purple

Re: Connecting a 9216i toa 6509-E using Hybrid Mode OS.

Hello,

can you post the relevant configurations of the 6509, the MDS, and the routing module ? Maybe something can be spotted...

Regards,

GP

Re: Connecting a 9216i toa 6509-E using Hybrid Mode OS.

Do a sh interface gi x/y switchport on the Sup 720 (assuming this is IOS based). this will tell you if the port is in trunking status or not.

are you able to ping on vlan 1 ? (native)?

125
Views
0
Helpful
2
Replies