I have taken the CCNA class and have since gotten my hands on a couple of 2500 routers for practice. One thing that I didn't do in class was pay attention to the cables that were used to connect the two routers. Can anyone help?
The 2500 serial ports use a 60 pin connector....the cable is called a DB-60 to DB-60 back to back cable. You can order some cheap at many websites. One such would be www.anthonypanda.com. YOu might even get some of them cheap at ebay.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...