Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Connecting ( leased line ) 4 wire, sync 64 kbps CSU/DSU to 1600 series router.

I have 1601 R series router. I want to connect (leased line) 4 wire, 64 kbps CSU/DSU to serial port(S0). Which cable I should use? how to configure the router? I am using RAD HCD-E1/2w/AC/S1/1/V35 leased line modem. It is having one synchronous data port with V35 interface. I want router configuration for this modem.

1 REPLY
Anonymous
N/A

Re: Connecting ( leased line ) 4 wire, sync 64 kbps CSU/DSU to 1

You can connect the CSU/DSU to the

built in serial port or to a WIC-1T.

You need to use the CAB-V35MT cable.

The router config depends on what

is at the other end; if it is a non-

cisco device, you should use PPP

encapsulation, along with an IP address

(as a minimum).

114
Views
0
Helpful
1
Replies
CreatePlease to create content