I just wanted to confirm that this configuration would work:
We are connecting our offices via a point-to-point Clear Channel DS1 that requires B8ZS/ESF framing. I am planning on using two Cisco 2610 Routers with integrated WIC1-DSU-T1 cards. My questions are...
How would I best configure these cards to use clear channel ds1 (no channelization) and to use HDLC as their encapsulation. Also, I need to configure clock speed as there is no clocking on the line.
What would I configure the clock speed for on the DS1 line (1.544Mbps)?
Do I have to configure clock speed on both devices or only one and then set the other to line?
LAN --- Cisco 2610 W/WIC ---- DS1 ---- Cisco 2610 W/WIC --- LAN
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...