Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

connecting to multiple sites via isdn bri

If I set this up, do I need to create multiple dialler interfaces or can I use just one with lots of dialler maps ? and how do I set this up ?

thanks everyone

3 REPLIES

Re: connecting to multiple sites via isdn bri

Hi,

you could setup multiple dialer interfaces.

An example is found here:

Configuring ISDN DDR with Dialer Profiles

http://www.cisco.com/en/US/tech/tk801/tk133/technologies_configuration_example09186a0080093c2e.shtml

Hope this helps

Martin

New Member

Re: connecting to multiple sites via isdn bri

Hi there

thanks for the reply, I saw the other day on one of our routers, it was an isdn pri, isdn 30, I am right in saying that you dont need dialler profiles for this, just dialler maps, and then do you just point the route for the subnet to the ip address on the dialer map, i.e dialer map ip 172.19.1.1 name test 011644848494 etc, then would i put a static route for that complete subnet to the 172.19.1.1 router ?

thanks

Carl

Re: connecting to multiple sites via isdn bri

hi

To have the reachability to the remote locations network u need to enable the static route pointing via 172.19.1.1..

regds

115
Views
0
Helpful
3
Replies
CreatePlease login to create content