Connecting to Unix based systems using Cisco2509 TS
I woold like to manage Unix based system via the Console port ( SERIAL PORTS RS232). I have Cisco 2509 TS and would like to connect the Unix servers to the Cisco 2509 TS so that i can reach the systems directly via the Serial Port.
1- Hase anybody an idea which cable should i use between the Cisco 2509 TS and the Serial Port ( RS232 ), or with which cable should i extend the the cable delivered with the Cisco 2509 so that i can connect to the serial port.
2- Is there any special configuration for such a connection.
Re: Connecting to Unix based systems using Cisco2509 TS
Do u mean, i can extend the cable delivered with the 2509 ( 72.0845-01) which is connected to the Async interface on the router.
I have the following
Router 2509 withe Async 1-8 interface ,an Octal Async Cable which is at one end connected to the Async interface of the router. The other end of this Cable is an RJ45 connector which usually used connect to the console interface of cisco devices. I need to connect this end to unix based machine via the serial interface which is an DB9 RS232.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.