Connecting Two Cisco 2500 series Routers together.
I have two router 2500 series, one of them is ethernet has a AUI and Console port RJ45 connection and a AUI port (serial) the other has a AUI and a console RJ45 but the other connection is a Tokken ring. Is there a way i can connect the two of them together? If so how can i do it.
Re: Connecting Two Cisco 2500 series Routers together.
Can you tell us what models they are? 2501, 2503, 2514, etc. That would help us figure out exactly what options you have.
If you are looking to connecct them via Ethernet, first you need two AUI-to-10BaseT transceivers, to convert those AUI ports to something useful. Then use an Ethernet cross-over cable to connect the two transceivers. Done.
If you have a serial port on each router, you can get a custom null-modem cable that goes between the two routers. Or if you have two V.35 cables, one for DTE and one for DCE, you can connect these. Then, configure a clockrate command on the one attached to the DCE cable. Done.
If you want to just connect via the AUX ports (these look like RJ-45 connections, right next to the CONSOLE ports), you can do that, too. Here's a link:
Connecting Routers Back-to-Back Through the AUX Ports
If you're looking to set up some sort of lab environment, keep in mind that any LAN and WAN interfaces you assign network address information to will come up and be useful ONLY when they're connected to something else. For example, the two Ethernet ports connected back-to-back, or a port into a hub/switch port; a Token Ring port, only if it's plugged into a Token Ring hub or MAU; serial connection only if it's matched up with something on the other side.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...