Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

connecting vlans to router

If I create a sub if on my router, do I have to create 1 for each vlan or can I assign to vlans to 1 sub interface ?

1 REPLY

Re: connecting vlans to router

Hi

AFAIK if u r going on for intervlan routing then you can assign one vlan id followed by the encapsulation dot1q command.

but if you are terminating Q-in-Q Frame you can have secondary vlan id followed by the primary one..

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fswtch_r/xrfscmd1.htm#wp1056958

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcr/tmpls_r/mpl_a1ht.htm#wp1016968

regds

95
Views
0
Helpful
1
Replies
CreatePlease to create content