Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

connection between Cisco 2950 and an Alcatel switch

Hello everybody,

I try to cascade a cisco 2950 with an alcatel switch ( with a cross cable) and then about 2 mn later the Cisco 2950 is re-booting.

I already try to put 10/half and spanning tree portfast on the cisco port used for the connection betwen the 2 switches but it's still the same...

Is someone has got an idea about this problem???

Many thanks and best regards.

Jerome

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: connection between Cisco 2950 and an Alcatel switch

Did you try reinstalling your IOS image or upgrading to a new one. I don't remember hearing of such a problem and IOS corruption seems to be the likely cause.

2 REPLIES
Bronze

Re: connection between Cisco 2950 and an Alcatel switch

Did you try reinstalling your IOS image or upgrading to a new one. I don't remember hearing of such a problem and IOS corruption seems to be the likely cause.

New Member

Re: connection between Cisco 2950 and an Alcatel switch

Hello,

In fact it's exactly what i do ( i put the last IOS version on this catalyst) and then everything was working well.

Many thanks and regards.

Jerome

113
Views
0
Helpful
2
Replies