Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Connection Files for RTM 1.4

I wish to add a link to RTM 1.4 to Ciscoworks, but I can only import the connection document for 1.2. Is there a way to upgrade the connection document? Do I have to add it manually?

1 REPLY
Blue

Re: Connection Files for RTM 1.4

The RTM 1.4 installation dynamically creates Cisco Management Connection (CMC) files for each available application; these files initially reside in the \rtm\bin folder (on Windows systems) or /rtm/bin (on Solaris systems).

nGeniusS.lf--For nGenius Server

nGeniusT.lf--For Traffic Monitor

nGeniusK.lf--For Packet Analyzer

nGeniusV.lf-For Voice Monitor

Before starting the RTM installation, you must manually create the NMSROOT environment variable and reference the root directory where the CW2000 software is installed.

If CW2000 and RTM are installed on the same system, the files are copied automatically to this CW2000 folder:

On Windows: $NMSROOT\htdocs\xml\public\maintree

On Solaris: $NMSROOT/htdocs/XML/Public/maintree

CW2000 uses these files to create menus to launch nGenius Server, Traffic Monitor, Packet Analyzer and Voice Monitor.

If CW2000 and RTM are installed on different systems, or if nGenius was installed before CW2000, you must manually copy the CMC files to the location specified in the CW2000 installation.

After the CMC files are in place, you must reboot the system for the changes to take effect. Then, when you select nGenius Server, Traffic Monitor, PacketAnalyzer, or Voice Monitor, an nGenius graphic is displayed in the main CW2000 window (Management Connection) and the selected application starts. The nGenius

system administrator might create the same users and apply the same privileges from CW2000 to the nGenius system.

83
Views
0
Helpful
1
Replies
CreatePlease to create content