I want to use ccp to make it easier for my new users to setup/configure our cisco devices. I was able to install the ccp have it working but when i launch a configuration command it stuck in loading. and it will prompt "The connection to the device x.x.x.x has been lost. Rediscover this device to continue work" unfortunately even if i rediscover my device and load the settings i want to change it will hang again and will prompt same error.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...