Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Connectivity checking on site-to-site

Hi all,

these 2 sites are connected with fiber-optic through 2950G-xl-en switches. Same vlans (1-11) being configured on both switches.

I also configured vlan trunk on port gi0/1 on both switches. The command is "switchport mode trunk". No encapsulation is configured, as it defaulted to dot1q. I checked by typing "show int gi0/1 switchport", "show int gi0/1 trunk"; both are having the same results.

Any thing wrong with my configuration?

Thanks in advance!

3 REPLIES
Purple

Re: Connectivity checking on site-to-site

Your configuration seems perfectly okay. Are you having any issues ?

Paresh

New Member

Re: Connectivity checking on site-to-site

By the way, should I configure default gateway on the switches?

Purple

Re: Connectivity checking on site-to-site

You should configure the default gateway on both switches so that they can route to any management segments that need to access the switches.

Pls do remember to rate posts.

Paresh

96
Views
0
Helpful
3
Replies
CreatePlease to create content