Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
292
Views
0
Helpful
2
Replies

Connectivity Problem with NM 4T & WIC 2T

mmali
Level 1
Level 1

‎03-31-2003 12:27 AM - edited ‎03-02-2019 06:16 AM

Hi,

I have Cisco Router 2610 with WIC 2T, & Cisco Router 3640 with NM 4T.

Connected back to back.

What is the configuration should i apply for this routers to make a connection.

Also i want to know compatilibity of NM 4T with 2610 Router.

Regards,

Mudassir.

Labels:
0 Helpful
2 Replies 2

a.manosca
Level 4
Level 4

‎03-31-2003 12:56 AM

There should be no special configuration required when connecting the routers back-to-back. We have even tried connecting a 1700 with the 3640's NM-4T with no problem. Just set the IP addresses on both routers and a clocking on the router with the DCE cable. NM-4T is not supported on 2600 series.

0 Helpful

mmali
Level 1
Level 1
In response to a.manosca

‎03-31-2003 01:13 AM

I tried clocking 115200. but it is not excepting it.

it is taking 240.

interface shows down down.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents