Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Connectivity Problem with NM 4T & WIC 2T

Hi,

I have Cisco Router 2610 with WIC 2T, & Cisco Router 3640 with NM 4T.

Connected back to back.

What is the configuration should i apply for this routers to make a connection.

Also i want to know compatilibity of NM 4T with 2610 Router.

Regards,

Mudassir.

2 REPLIES
Bronze

Re: Connectivity Problem with NM 4T & WIC 2T

There should be no special configuration required when connecting the routers back-to-back. We have even tried connecting a 1700 with the 3640's NM-4T with no problem. Just set the IP addresses on both routers and a clocking on the router with the DCE cable. NM-4T is not supported on 2600 series.

Community Member

Re: Connectivity Problem with NM 4T & WIC 2T

I tried clocking 115200. but it is not excepting it.

it is taking 240.

interface shows down down.

109
Views
0
Helpful
2
Replies
CreatePlease to create content