I have two identical (1600) routers. I can get into one of them with a console cable but I get no response from the other. Any suggestions as to why? Can, for example, the console port be disabled? If so, how would I tell and how would I enable it?
It cannot be disabled but the speed setting can be changed by changing the config register settings. The default speed is 9600 but it can be set to 4800, 2400 or 1200 so try connecting at these speeds.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...