Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Console management

I would like to console into any of my 30 cisco devices from anywhere on my network. Anyone have a suggested device to terminate all the console connections? It would be a device that can be placed on the network with an IP and then connect to that device and choose which device to console to. Any advice would be greatly appreciated. Thanks!

2 REPLIES
Cisco Employee

Re: Console management

A 2600 with nm-32a and octal cables would do fine - provided the cables can reach. Otherwise you may need to get a couple 2600 and small port density async card. They come in 4,8,16,and 32.

Re: Console management

Get a 2600 with NM-32A, the necessary Octal cables (you will need 4 of them). And use the following configuration.

http://www.cisco.com/warp/public/793/access_dial/comm_server.html

The configurations are for a 2500 but its no different than the 2600. You could also use 4 2509s, if you can get it cheap off ebay.

91
Views
0
Helpful
2
Replies
CreatePlease to create content