02-28-2003 12:54 PM - edited 03-02-2019 05:29 AM
Hey all, did a dumb thing. I thought I was tightening up access to some of my swtiches and I wanted to do so with the console port as well. Now when I try to connect to the port it is asking a user verifcation. prompting me for a username. I haven't created any. I have tried cisco, enable, admin, telnet. Are there any others. If not, what can I do to get back into the console. Telnet has yet to be configured on this 2950-12 switch.
It's one of those days
Thanks
Matt
02-28-2003 01:03 PM
Matt,
Couple choices.
1. If you've not written the config to memory you could reboot and get back to where you were.
2. REboot and break into romMOn and change configuration register to 0x2142 to perform a break in and copy your start-up config over to running, change your passwd, and change the config register badk to 0x2102 or whatever it was set to.
Hope this helps,
Don
02-28-2003 01:09 PM
You will need to do a password recovery
http://www.cisco.com/warp/public/474/pswdrec_2900xl.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: