Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Continuous Callback To Remote User

Hi all, my dilemma is as follows:

1. my home user dials into the 2600 NAS router & the router calls her back

2. she abnormally terminates her windows session

3. she connects her phone back to the telephone jack

4. the router then calls her back (phone rings)

5. if she picks up the handset & terminates the call the router still dials her

6. the only way we are currently dealing with this problem is to reboot the router

Is there any command to tell the router to only attempt callback x number of times? Do you think there may be a problem with the users modem drivers?

Regards

Lincoln

  • Other Network Infrastructure Subjects
3 REPLIES
Cisco Employee

Re: Continuous Callback To Remote User

New Member

Re: Continuous Callback To Remote User

Thanks Yusuff, I am sure that command will rectify my problem ...

Regards

Lincoln

Bronze

Re: Continuous Callback To Remote User

Actually, callback should only be tried one time - if we fail, we should give up. Without seeing the 2600 config, I can't say why she is getting a call all the time. You may want to ensure that you have recent IOS code on the 2600, just to be safe. If you want to troubleshoot this further, I would suggest you have a look at the following:

debug ppp neg

debug ppp cbcp

debug callback

debug modem

debug isdn q931

95
Views
0
Helpful
3
Replies