Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Controlling bandwidth on portchannel subport vlan routing

I am trying to figure out how to limit the bandwidth (rx and tx). My configuration is as follows:

multiple 2924 Switches

7206 VXR with dual FE ports configured as a portchannel and acting as a vlan router for the 2924 Switches.

I have a customer who has an ethernet connection into one of the 2924 switches. The port is on it's own vlan and I have set up a portchannel sub interface on the 7206VXR to route that particular vlan. What I would like to do is limit the actual bandwidth on that particular subinterface (on the Router, portchannel 1.100) to only allow a T-1's worth of bandwidth (I feel nice so giving him the full 1.544Mb/s).

We are running static routing at the moment but I'm definately open to suggestions...

Here is the router config:

int Port-channel1

no ip address

hold-queue 150 in

!

int Port-channel1.2

encapsulation dot1Q 2

ip address xxx.xxx.xxx.1 255.255.255.0

!

interface Port-channel1.100

encapsulation dot1Q 100

ip address yyy.yyy.yyy.1 255.255.255.0

!

interface FastEthernet0/0

no ip address

duplex full

speed 100

channel-group 1

!

interface FastEthernet 0/1

no ip address

duplex full

speed 100

channel-group 1

Thanks...

  • Other Network Infrastructure Subjects
1 REPLY
New Member

Re: Controlling bandwidth on portchannel subport vlan routing

Solved... Thanks...

130
Views
0
Helpful
1
Replies