Here's the issue. I have 4 switches currently and I am adding 3 more. Each switch is setup for VLANS but in VTP Tranparent mode. I would like to make one of the switches a VTP server and then make the others clients so I no longer have to make the changes on each switch.
My Question is, will I lose the currently VLAN config when changing from transparent to server?
No, you wont be losing the VLANs when changing from Transparent to Server mode.
Please be extra careful when changing VTP modes and pay close attention to configuration revision # and make sure there's not another server out there because by default all switches are in Server mode.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...