Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

copy data

we have two 6513 switches as core, but only 1 IDSM2 module on switch 1, the connection between the two swithches is layer 3? how we can copy the traffic from the switch 2 (without idsm2) to the switch 1 (with idsm2).

2 REPLIES
Blue

Re: copy data

to 'copy traffic data from switch1 to switch 2' you would use the SPAN techniques to setup port or vlan mirroring or 'spanning'.

please see the following link for setting up SPAN on the 6500:

CatOS -

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a00801a5b33.html

IOS -

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a008007e6fa.html

New Member

Re: copy data

thanks for reply, but span done on the same switch secondly span and rspan used if we have layer 2 not layer 3.

109
Views
0
Helpful
2
Replies
CreatePlease to create content