Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

copy running-config to startup fails

Says <no device>

I'm using a 6513. Anyone seen this ?

Thanks

5 REPLIES
Hall of Fame Super Silver

Re: copy running-config to startup fails

Mickey

I have seen errors like this when I was doing a copy and had mis-spelled or somehow changed the name of the destination.

Can you try it again being very careful about names and spelling. If it still does not work can you cut and paste the exact command you entered and the response from the 6513. Also would you post the output of show version.

HTH

Rick

New Member

Re: copy running-config to startup fails

Thank for the reply:

switch#copy run start

Destination filename [startup-config]?

startup-config file open failed (No such device)

Hall of Fame Super Silver

Re: copy running-config to startup fails

Mickey

Thanks for this additional information. How about the output of show version?

HTH

Rick

Bronze

Re: copy running-config to startup fails

Can you do a "sh filesystems" and "dir nvram:" and post it?

Bronze

Re: copy running-config to startup fails

Also if you do a "wr mem" after the "dir nvram:" above then another "dir nvram:" post these.

so

1. dir nvram:

2. wr mem

3. dir nvram:

Thanks

192
Views
0
Helpful
5
Replies