This should be a simple question to answer, but I can't find what I am looking in any doc. Anyway, when I do a 'copy tftp running-config', is there a way that the IOS will verify the config I am sending? If there are any errors, display the error and not execute any of the config that was sent. By this I mean, if any error occurs, don't apply anything that was in the config from tftp. Just verify the whole config before you start. Right now, I sometimes get resulting configs that are not what I want because some IOS commands were executed in the wrong context (ie, global bgp section instead of in the bgp address family).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...