Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CoS in 4500 L3

Hi everybody:

Do you know if there is a way to check the CoS in a Catalyst 4500? I mean I want to see with commands the CoS that I´m receiving in a port with ip phone, my module is WS-X4248-RJ45V.

TIA.

1 REPLY

Re: CoS in 4500 L3

You could try to setup a policer to do the CoS checking for testing purposes. You could also use a SPAN port and a packet analyzer.

The other possibility would be to insert a hub between switch and ip telephone and use a packet analyzer. But then you loose power over ethernet.

Hope this helps

Martin

100
Views
0
Helpful
1
Replies
CreatePlease to create content