Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cossover between WS-G5482

Can everybody give me the correct pinouts for the cable to connect two catalyst's 3524 with ws-g5482(1000T-copper). Is this a one-to-one-cable or a crossover-cable and with which pin-connection?

2 REPLIES
New Member

Re: Cossover between WS-G5482

Here is an interesting white paper.

http://www.mohawk-cdt.com/wp/index.html

From this, I can state that all 4 pares are used and it is bi-directional. While it would seem to imply that crossovers are not required, I could not find that in print.

Regards;

Doug Lockwood

New Member

Re: Cossover between WS-G5482

1000BaseT GBIC's do cross-over sensing but fixed 10/100/1000BaseT ports don't, so when connecting anything to a GBIC (WS-G5482) you can use any CAT5e 8-wire cable, but when connecting 2 10/100/1000BaseT ports you do need a cross-cable with all 8 wires crossed like this:

http://www.cabling-design.com/references/pinouts/1000base_t_crossover.shtml

Regards, Maarten Sjouw

165
Views
0
Helpful
2
Replies
CreatePlease to create content