Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Could 2600 damage an NM-2FE2W ?

While the Cisco documentation clearly states that the NM-2FE2W module is not supported by the 2600 series, would any damage to the NM take place if it is installed in a 2600 chassis (and powered up).

For example, is there any power differences between 2600 and 3600 NM slots ?

The reason I ask is that I have a NM-2FE2W that causes a 3600 to hand when booted...and am wondering if it was perhaps mistakenly installed in a 2600 at some time in the past.

1 REPLY
Silver

Re: Could 2600 damage an NM-2FE2W ?

This is quite possible though I myself have not faced this situation. You can check the data sheets of the products to see information about power rating and other specifications.

206
Views
0
Helpful
1
Replies
CreatePlease to create content