03-24-2003 06:53 PM - edited 03-02-2019 06:07 AM
Sir,
My cpu utility on C4k is always high even with any configuration and connection. After I remove a 4232 module, everything is ok. Please help me identity the problem.
Thank you very much!
Regards,
Sha, Haijiang
===================================
Console> (enable) sh proc cpu
CPU utilization for five seconds: 21.33%
one minute: 33.96%
five minutes: 24.97%
......
145 263 242 5000 0.00% 0.00% 0.00% -2 VtpRx
193 430939 54246 10958 1.30% 1.44% 12.38% 0 Packet forwardi
194 257203 69837 6468 15.70% 15.29% 16.72% 0 Switching overh
195 31091 54063 18817 1.96% 2.02% 1.97% 0 Admin overhead
......
===================================
Here is my c4k's module:
Mod Port Model Serial # Versions
--- ---- ---------- -------------------- ---------------------------------
1 2 WS-X4013 JAE0548xxxx Hw : 3.2
Gsp: 6.2(2.0)
Nmp: 6.2(2)
2 34 WS-X4232-L3 JAB0547xxxx Hw : 1.7
3 34 WS-X4232-GB-RJ JAE0548xxxx Hw : 2.3
03-24-2003 07:02 PM
Normal for a CAT4006
03-24-2003 07:20 PM
Sir,
Thank you first!
I read the document. I don't think it's normal.
The switchover traiffic are:
Address learning;
STP traffic;
control traffic;
management traffic;
Now there is not any connection and configuration. Except little control traffic, i don't think there are enough traffic would use switching overh process.
And after i remove a 4232 module. The cpu utility would drop.
Thanks again.
Regards,
Sha
03-24-2003 09:11 PM
Agree, if I am not wrong, the 4232 module is the worst case causing other unexpected system crash when plug-in some multi-mac connection.
Don't any patching or solution from Cisco available.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: