Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CRC Errors on From Cat4006!!!

Hi,

I'm having persistent CRC errors when I connect anything to one of my CAT 4006 switch ports(WS-X4412-2GB-T line card).

All connected switches report rxCRCAlignerrors and users lose connectivity to Servers and the Internet. FCS Rcv errors pile up!!

I've replaced:

i) Line Card (WS-X4412-2GB-T 12 Cat 1Gb/s and 2 Fiber 1Gb/s).

ii) Supervisor II Engine

iii)Patch cables

iv) Changed from 2980 to a 3548 switch

v) Upgraded IOS from 6.3(5) to 7.4(2) on the CAT4K.

vi) Changed Fiber Pairs.

Nothing works so far.

Any Ideas???

2 REPLIES
VIP Purple

Re: CRC Errors on From Cat4006!!!

Hello,

I would check if any remote devices are sending the bad frames. According to Cisco, CRC errors can also come from a remote device attached via an ISL trunk. Most Catalyst line cards do not check the CRC of a packet they receive from the backplane and forward on a trunk. Can you connect a sniffer to your switch ?

Regards,

GP

Cisco Employee

Re: CRC Errors on From Cat4006!!!

Is it happeningly only on 1 switch port of the 12? If so, which port? Or does it happen on all ports. If it happens on any port, then you probably need to look at what is connecting to the switch.

Generally, fcs rcv errors are a result of duplex mismatch.

167
Views
0
Helpful
2
Replies
CreatePlease login to create content