08-22-2006 09:41 PM - edited 03-03-2019 04:38 AM
Hi
I have 4 links which are bundled together in multilink.
I receive lot of CRC errors in 2 links and hence i removed them from the bundle and gave them for testing.
The circuit was clean and did not produce any errors for 24 hours.
But as soon as i add it to the bundle the CRC errors increments.
Is there anything specific to multilink which i am missing while testing?
08-22-2006 10:59 PM
Could you please advise what is the interface type you are using. I suspect it is the cable problem to cause the CRC error. Did you try to replace the cables ?
Hope this help.
08-22-2006 11:44 PM
Hi Jack,
The interfaces are E1.
I dont think its a cable problem cos i dont see the errors when i remove them from multilink eventough the same physical link is connected on the interface.
Anyway i will have it tested.
Narayan
08-23-2006 12:34 AM
Thanks for your update. IC. I suggest to carry a loopback test with the CSU/DSU by the provider.
Check below for the E1 troubleshooting :
http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a70fb.shtml
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide