Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

crypto maps

Hi all, if im seeting up a crypto map between 2 routers or pix's on a WES (lan extension circuit) have the ethernet interfaces got to be on the same ip subnet between them ? does the crypto map use the ip of the physical interface or does it have its own ?

1 REPLY

Re: crypto maps

Hi,

Among other things, the crypto map need to specify Remote Peer IP Address. Same goes to the config on the other side.

This crypto map will later be associated or configured on the outbound interface facing the remote peer interface receiving the VPN Phase I&II sessions.

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a008049d04c.html#wp1047992

Crypto map can specify static or configured in dynamic mode (no IP specify).

Pls rate helpful post.

Rgds,

AK

93
Views
0
Helpful
1
Replies
CreatePlease to create content