I'm testing 802.1x with a Cisco 2950 switch with image c2950-i6q4l2-mz.121-22.EA4.bin and CTA ver 184.108.40.206 with 802.1x supplicant.
Everything works fine, including single sign on. However, I noticed a long delay after providing the login credentials and loading the personal settings after logon. There's some hard disk activity during the process. When I revert to MS 802.1x, I don't have this problem.
Are there any settings that I need to do to speed up the login process?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...