Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ctrl Break using Compaq notebook??

Firstly, i spologize for everyone..

I know but i can't find where is board about this kind of question...:)

Now, I'm using Compaq Presario 2851AP.

Using this, I can't give Ctrl Break signal so never get Rom Monitor of router..

If anybody use Presario 2800 or something and know how, let me know that.

Thanks HJ

3 REPLIES

Re: Ctrl Break using Compaq notebook??

Try holding down the Function (Fn) key first and then doing a Ctrl Break

New Member

Re: Ctrl Break using Compaq notebook??

I know that.

And I did try below document...But I coundn't

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml

Thanks

New Member

Re: Ctrl Break using Compaq notebook??

If you're using the version of Hyperterminal that came standard with the operating system, that might be your problem. Try upgrading to Hyperterminal Private Edition and see if that works.

223
Views
0
Helpful
3
Replies
CreatePlease login to create content