We are in the process of deploying enterprise-wide (about 300 routers and 1000 switches) configuration changes, such as SNMP and AAA etc., and would like to use CW2K to perform the changes. Can anyone explain to me:
1. How to generate customerized report of the inventory with loopback IP address and IOS/COS version? Can this customerized report being utilized in the future for the configuration deploying?
2. Are IP addresses in CW2K's report unique, it means that they will be the same no mater when you are going to do the discovery and how. We need to put them into ACS 3.1 database so that the changes for AAA can be performed through CW2K.
Customized Config Reports can be generated in RME based on View and/or Pattern matching. Similarly, Custom Inventory Reports can be created in RME Inventory by selecting one of the available Report Type options. IP Address is one option available.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...