I have to customize some of the Web Pages for Router MAnagement. I was looking at SSI to do this, but not sure if this can fulfill my requirement.
What i want to do is basically run a command like,
Which returns me a bunch of users in form of a html page. But i need to display each of the user in a combo box. As far as i understand programatically i can do this if i can get an array of users inspite of in an html page and then i can iterate through this array and add in the combo box.
So is this kind of requirement do able with the HTTP Interface. Any idea or sample would be highly appreciated.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...