CW2000 and RCP

[milan.kulik]

I've installed my CiscoWorks2000 on Win2000 server recently.

I'm trying to configure my network devices to use RCP for config file transfer to my CW server.

Regarding to http://www.cisco.com/warp/public/477/RME/rcp.shtml I've configured

username cwuser password 7 .........

ip rcmd rcp-enable

ip rcmd remote-host cwuser x.x.x.x cwuser

ip rcmd remote-username cwuser

on my 3550 router.

I've also doublechecked all instructions regarding CW server configuration mentioned in http://www.cisco.com/warp/public/477/RME/rcp.shtml.

But turning debug RCMD on I'm receiving:

Dec 20 13:04:49.233: RCMD: [514 <- x.x.x.x:3352] recv \0

Dec 20 13:04:49.433: RCMD: [514 <- x.x.x.x:3352] recv cwuser\0cwuser\0rcp -f running-config\0

Dec 20 13:04:49.433: RCMD: [514 -> x.x.x.x:3352] send <OK>

Dec 20 13:04:49.433: RCMD: [514 <- x.x.x.x:3352] recv <OK>

Dec 20 13:04:49.433: RCMD: [514 -> x.x.x.x:3352] send <BAD,Permission denied.>\n

My feeling is that there is necessary to configure cwuser password somewhere in CW server configuration - I've set the password on the router so it should be set the same value on the server, shouldn't it?

But I've not found any cwuser password dialogue box.

Another question:

How to configure the same feature on CatOS devices where no user passwords are used?

Thanks,

Milan

[#2]

For informtaion regarding configuration of network devices, you can use the follwoing URL:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/camp_mgr/cwsi_2x/cwsi_2_3/mgr_sol/solinstl.htm

[milan.kulik]

Thanks,

but the link you provided is about Solaris, I'm running my CW2000 on Windows 2000.

Regards,

Milan